Where to find your ip address on windows vista

Again, the exact steps will vary for differentprinter makes and models. Check your device manual on the exact stepsto follow. For models without a user interface display, you will need to press and hold a certain button usually this button is labeled as Power, Go, or in some cases, the Wi-Fi button for five to 10 seconds to print a configuration page. Tap Wi-Fi. The screen shown below appears. Tap the connected Wi-Fi network. Also the site you mentioned, provides inaccurate information about your Internet address and location.

I am trying to use the windows microsoft encoder 9 for a radio internet, and I cannot pull the real IP. I have a speedtouch modem-router? Help would be nice. I want to keep my router, because we have 2 computers at home. Otherwise, I could solve the problem just by connecting directly to the internet. Click here to cancel reply. Notify me of followup comments via e-mail. Subscribe without commenting E-Mail:.

Therefore, make sure that you follow these steps carefully. For added protection, back up the registry before you modify it. Then, you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article number to view the article in the Microsoft Knowledge Base:.

To do this, follow these steps:. Click Start , type regedit in the Start Search box, and then click regedit in the Programs list. If you are prompted for an administrator password or for confirmation, type the password or provide confirmation. Remember this GUID. To find the corresponding GUID, refer to step 2 and step 3.

In the Value data box, type 1, and then click OK. A value of 0 disables the registry entry. Details required :. Cancel Submit. Al Jarvi. What type of network device are you trying to connect to? Are you sure the IP on the network device and the static IP your selecting are in the same range, ie.

X for example? If the network device is using a different subnet than the laptop that would cause this issue. Have you tried a cross-over cable versus a straight patch cable?

How satisfied are you with this reply? Thanks for your feedback, it helps us improve the site.